Submersible pump comprehensive monitoring controller, winding overheating, motor overload, oil chamber leakage protector
. Overview
Type water pump comprehensive protector> (hereinafter referred to as the protector) is suitable for the protection and control of submersible sewage pumps, clean water pumps, B axial flow pumps, and B mixed flow pumps produced by Nanjing Lanshen Pump Group Co., Ltd. Or all other similar water pumps, such as Kaiquan, Kaishili, B, etc.
． Scope of application
The controller is panel mounted and can work normally under the following conditions:
The ambient temperature does not exceed >+ degrees, the average temperature within an hour period does not exceed + degrees, and the minimum ambient temperature must not be lower than Yudu.
There must be no excess dust or acid in the air
Input voltage: >,, rated, salt, corrosive gas, relative humidity shall not exceed when the maximum temperature is + degrees, and higher temperatures are allowed when the temperature is lowered. relative humidity.
For example: When the humidity is below 10 degrees, you should be careful about condensation that may occur accidentally due to temperature changes.
The altitude of the installation site shall not exceed > meters.
The vertical installation inclination shall not exceed > degrees.
.>
Performance features
Power consumption is less than >.
Ambient temperature:> ℃～℃.
Ambient humidity:> below (no water condensation).
Sensor power supply: Sensor>C low voltage power supply
Power supply transformer isolation.
Signal input: Input hysteresis control: [banned words]>
Signal input: >C switch signal input or resistance, current signal input
Signal response speed: >.
Signal output: relay output, contact capacity: >/C or /C.
Signal input:> Winding sensing: winding overheating protection
Bearing overtemperature sensing: bearing overheating protection
Overload signal: motor overload protection
Wire box water immersion sensing: wire box Water immersion protection
Motor cavity water immersion sensor: Motor cavity water immersion protection
Oil chamber sensor: Oil chamber water leakage protection
Dehumidification sensor: Heating and dehumidification, to prevent motor insulation from falling and heating and dehumidification
Pump operation signal: Pump operation monitoring.
NS-42 submersible pump comprehensive monitoring controller winding overheating motor overload oil chamber leakage protector